Operation process and maintenance of fully automatic delivery bed

A. Versatility, with supine position and lithotomy position, can be used for maternal delivery, obstetrics and gynecology vaginal surgery, obstetrics and gynecology examination, etc. the

B. Flexibility, the appropriate height can be adjusted according to the different heights of midwives. the

C. For comfort, the position of the head and buttocks can be adjusted according to the requirements of the parturient. the

2. Preparation before operation

A. Check whether the performance of the delivery bed is intact. the

B. Check whether the rated voltage of the delivery bed is consistent with the power supply voltage, and whether the grounding is reliable, and it can be used only after it is correct. the

3. Operation steps

A. Turn on the power, check and debug whether the delivery bed is in good condition. the

Adjust the back bed board from 0-75° to adjust the knee bed board angle from 0-45. Make adjustments and pull up the guardrail to confirm whether it is locked firmly. When starting to run, step on the upturned end of the caster lock, and when the lock is released, when the operation stops, step on the lock to 45°, and shake the bed to confirm that it is locked. the

B. Lightly step on the corresponding switch on the foot switch to complete the control of the delivery bed. the

C. The functions of the delivery bed are: table up, table down, backboard up, backboard down, head up, buttocks up. the

D. Lay out the large middle sheet and the small middle sheet so that the delivery bed is in a standby state. the

E. Assist the patient to move to the delivery bed and take the lithotomy position. Explain the precautions and cooperation points to the patient. ``

F. Put the patient in a comfortable position according to personal needs. the

G. Cut off the power supply of the delivery bed, and then turn off the main switch. the

H. After use, clean and disinfect the delivery bed. the

4. Matters needing attention

A. When not in use or in standby, lower the machine to the lowest point; unplug the power cord when not in use for a long time. the

B. Remember that when the foot switch is not operated, it cannot be pressed by any object to avoid the machine from malfunctioning. Doing the action to the limit for a long time will keep the solenoid valve coil energized, which will burn the solenoid valve coil or overheat the motor. the

C. The motor has an overheating protection device. When it is turned for a long time, the motor will overheat and stop running automatically. It takes about 30 minutes of standby time for the motor to cool down before it can run normally again. the

5. Routine maintenance

A. After each use, clean all contaminated surfaces with 1000mg/L chlorine-containing disinfectant, then wipe with detergent, and finally wipe with clean water. Do not wash it directly with water to avoid damage to electrical parts or risk of electric shock. the

B. When the machine breaks down, please stop using it immediately and report it to technical personnel.